To apply Export to a logical unit, highlight the specific Virtual Volume associated with the Logical Unit in the GUI and right click and select Export. There are no constraints on which ports or hosts a logical unit may be addressable. Ports being identified by a node : slot : port representation. The Ports are designated at setup and configured separately as either Host or Target (Storage connection). VLUNs are exported through the HPE 3PAR storage array’s available FC ports by the export options on Virtual Volumes. *** Note: Delete the mdisk on the SVC Cluster before deleting the LUN on the HPE 3PAR storage array. To modify, resize, or destroy a VLUN, select the appropriate Virtual Volume from the window, right click when the specific VLUN is highlighted. To create a VLUN, highlight the Provisioning Menu and select the Create Virtual Volume option. VVs are formatted to all zeros upon creation. Virtual Volumes (VVs) and their corresponding Logical Units (VLUN's) are created, modified, or deleted through the provisioning option in the Management Console or through the CLI commands. The HPE 3PAR IEEE Company ID of 0020ACh, the rest is a vendor specific ID. The 64-bit IEEE Registered Identifier Extended (NAA=6) for the Logical Unit is in the form HPE 3PAR storage arrays will identify exported Logical Units through HPE 3PAR storage arrays can export up to 4096 LUNs to the SVC Controller (SVC’s maximum limit). A partition Virtual Volume is referenced by the ID of the VLUN. The HPE 3PAR storage array has a maximum Virtual Volume size of 16TB. HPE 3PAR storage arrays have highly developed thin provisioning capabilities. Logical units and target ports on HPE 3PAR storage arraysįor clarification, partitions in the HPE 3PAR storage array are exported as Virtual Volumes with a Virtual Logical Unit Number (VLUN) either manually or automatically assigned to the partition. #3par copy space windows#The CLI may be installed locally on a windows or Linux host. All configuration and monitoring steps are intuitively available through this interface. The Management Console accesses the array via the IP address of the HPE 3PAR storage array. Users may configure an HPE 3PAR storage array with the 3PAR Management Console or HPE 3PAR Command Line Interface (CLI). For support on later versions, consult Ĭoncurrent maintenance on HPE 3PAR storage arraysĬoncurrent Firmware upgrades (“online upgrades”) are supported as per HPE procedures. Support firmware levels of HPE 3PAR storage arraysįirmware revision HPE InForm Operating System 3.1.1 (or later) is the supported level of firmware for use with IBM SVC. Note Also requires HPE 3PAR OS 3.2.1 or later and Host Option 2 Generic - ALUA). Round Robin SVC MPIO is supported from these levels 7.5.0.10, 7.6.1.6, 7.7.0.5 These systems will be referred to as HPE 3PAR storage arrays. The HPE 3PAR Stor Serv (Models 7000, 10000) the HPE, Stor Serv (Models 800) are supported for use with the IBM SVC. Support models of HPE 3PAR Storage Systems This portion of the document covers the necessary configuration for using an HPE 3PAR Storage System with an IBM SAN Volume Controller cluster. The following revisions have been made to this document:Ĭonfiguring the HPE 3PAR Stor Serv Storage Systems This document was last updated: August 15, 2016 #3par copy space software#You should review the errata contained within this guide and note the details with respect to the copy of the Software Installation and Configuration Guide supplied with your SAN Volume Controller. This erratum should be used by anyone using the IBM System Storage SAN Volume Controller Software Installation and Configuration Guide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |